If you’ve enabled BPDUGuard on a your endpoint facing ports (which you should do) you’ve probably asked yourself what to do when those ports auto disable themselves after a switch is plugged into them. It’s pretty simple, first remove whatever caused the port to disable, such as a loop or another switch, and then enter the following command on your power connect:
# set interface active gigabitethernet 1/0/13
Assuming that port 13 is the port you want to reactivate.
This does not work
Correct solution is:
console(config)#interface ethernet 2/g4
Assuming you are re-enabling port 4 on switch 2
Ah yes, your commands look like they are for a 62xx, or a 54xx, the above were specifically for a 55xx. Thanks!
The command “# set interface active gigabitethernet 1/0/13” work very well for me on Dell 5548P model.
Thanks a lot!